Vacuum Regulator and Suction Bottle
- Application
This is a medical device to be connected with a vacuum outlet and used for adjusting and measuring the vacuum level in suction process. It can't be used alone, but with the whole vacuum pipeline system, as well as the suction bottle.
- Technical Data
Standard: the medical devices directive 93/42/EEC
EN ISO 10079-3:2000
Adjusting Range:
High 0-700 mbar
Middle 0-400 mbar
Low 0-160 mbar
Vacuum pressure gauge accuracy: 2.5%
Max flowrate: 40L/min (Air)
Operating temperature: 20ºC±10ºC
- Instruction for Use:
- Make sure the device is undamaged and that the probe is adjustable with the gas outlet connection;
- Make sure the regulator knob is left off;
- Turn the device off, press the green switch;
- To start the suction, push the red switch;
- Turn the front knob and adjust the vacuum level by closing the patient suction system;
- Connect the device to the wall vacuum outlet;
- Connecting the suction controller's outlet to the collection bottle, using a min. 6mm diameter hose;
- To start the suction, press the red switch knob;
- For a temporary stop, use the red/green switch knob, vacuum level will get back to its initial level when suction is back on;
- For a long stop, turn off the switch knob and the ON/OFF regulator's knob (suction system will be off)
- Sterilization
- The material of suction bottle is Polypropylene and is not autoclavable;
- Safety Advice
- Please read the instructions carefully before using the product;
- Always make a working test prior to any use with patients
- Avoid collision with the gauge as the pointer is fragile
- Make sure the pointer is on "0" when the device is not used
- Do not disassemble or repair the device when it is connected to the pipeline
- It's only for medical use
- Transportation, Storage and Warranty
- Please avoid shaking when it is in the process of transportation
- Between -10ºC and +40ºC (between 14-104ºF) in a dry and clean place
- Warranty: 1 year
- Common trouble-shooting
If the regulator is not working properly and the pointer is not pointing to "0", please change the regulator
If the aspirator is not sealing tightly, the float ball might be dirty. Please shut off the regulator valve, pull out the quick connector and clean the float ball and rubber cover.
If pressure is low, check the connector to see if there is leakage. Check the tube system.
- Maintenance advice
- Calibration of vacuum pressure gauge every 12 months
- Add lubricant to quick switch every 3 months, silicone grease or medical Vaseline are recommended
Suction Jar
| Capacity |
1000ml |
| Dimension |
Φ14*25 |
| Autoclave |
× |
| Material of Jar |
Polypropylene |
| Material of lid |
Acrylonitrile Butadiene Styrene |
| Connection tube |
Φ6-Φ8 mm |
1L SUCTION JAR/SCUTION BOTTLE/COLLECTING BOTTLE 2L SUCTION JAR/SCUTION BOTTLE/COLLECTING BOTTLE
){kind=link}
){kind=link}